DW800/820 Operation ManualSTERLING SCALE COMPANYDW800 HIGH ACCURACY WEIGHT INDICATORAND820 HIGH ACCURACY PIECE COUNTERUSERS MANUAL____________________
DW800/820 Operation ManualPARAMETER SETUP AND CALIBRATIONPAGE 7Name Values DescriptionZT 0 Zero tracking disabled(Zero Tracking) 0.2 Zero tracking at
DW800/820 Operation Manual LD2 Output format for LD2 printers *(See Printer Section) PARAMETERS SETUP AND CALIBRATIONPAGE 8Name
DW800/820 Operation Manual2. Once access is allowed to Parameter Setup, the NTEP parameter, along with its currentvalue is displayed.NOTE: NTEP shoul
DW800/820 Operation ManualPARAMETER SETUP AND CALIBRATIONPage 10Printer DriversThe DW800/820 can be provided with the following optional print drivers
DW800/820 Operation ManualPRINTERS Page 11Serial InterfaceThe DW800/820 has the capability of using one of the following serial interface: RS-232, RS-
DW800/820 Operation Manual08 +5VDC +5 Volt DC power09 GND Digital ground10 SHIELD ShieldThe RS-232 interface connector is P3 on the circuit boardCOMMU
DW800/820 Operation ManualCOMMUNICATIONPage 13Scoreboard Output FormatIf the Scoreboard Output Format is to be used then the Output Format parameter m
DW800/820 Operation ManualCOMMUNICATIONPage 14SpecificationsDW800 Physical SpecificationsMaterial: NEMA 1 Enclosure – ABS DFA/R with EMI/RFI shielding
DW800/820 Operation ManualSPECIFICATIONSPage 15OperationalInternal Counts: 18,777,215Display Counts: 10,000 recommended (50,000 maximum)Display Updat
DW800/820 Operation Manual* Time and Date* RS-422, RS-485, or 20 mA Current Loop* 4-20 mA or 0 – 10 VDC Analog Output* 220 VAC, 50 Hz OperationSPECIFI
DW800/820 Operation ManualTable of Contents
DW800/820 Operation ManualWARRANTY Page 17FCC NOTICEThis equipment generates, uses, and can radiate radio frequency energy. If this equipment is not
DW800/820 Operation ManualPage 18_____________________________________________________________________________________________________________Revision
DW800/820 Operation ManualPLEASE READ BEFORE ASSEMBLY INSTALLATIONUnpacking and InspectingUnpacking and Inspecting1. Upon receipt of the shipment, che
DW800/820 Operation ManualPin Name Description1 +EX + Excitation voltage (+10 VDC)2 +SN(+EX2) + Sense line 3 +SG + Signal line4 -SG - Signal line5 -SN
DW800/820 Operation ManualDesktop Enclosure Assembly DrawingINSTALLATIONPAGE 3________________________________________________________________________
DW800/820 Operation ManualJumper SettingsIn order for the 800/820 to operate as desired hardware, Jumpers must be set properly. Most of the jumper se
DW800/820 Operation ManualWeighing OperationWeigh Keys: During weighing operations the keys are used as follows:OPERATIONPAGE 5______________________
DW800/820 Operation ManualCounting OperationThe Counting Operation cannot be accessed, if the NTEP parameter is set to True (see parameter setup) or t
DW800/820 Operation ManualParameter Setup OperationParameter Setup may be accessed using the following method:1. From the Weigh Mode press and hold th
Commentaires sur ces manuels